s half-duplex. 1.4 Alarm In/Out Connections The network speed dome can be connected with alarm inputs (0~5VDC) and alarm outputs. Refer to the following diagrams for alarm output: GND OUT DC Load Dome Relay Output OUT(n) + DC - OUT(n) 30VDC 1A Dome OUT(n) JQC-3FG Relay (10 A 250VAC) 220V AC L N Relay Output OUT(n) Diagram (left) Diagram(right) Figure 1-12 Alarm Out Connections The alarm provides the relay output (no voltage), and the external power supply is required when it connects to the alarm device. For DC power supply (left diagram), the input voltage must be no more than 30VDC, 1A. For AC power supply, the external relay must be used (right diagram) to prevent damages to the speed dome and avoid risk of electric shock. 12 A-200 Installation Manual Chapter 2 Mount Dimension 2.1 A-200-WM Figure 2-1 Long-arm Wall Mount 2.2 A-200-CornerMount Please use the wall mount with corner adapter according to your requirements. 13 A-200 Installation Manual Figure 2-2 Corner Mount 2.3 A-200-PoleMount Ple
longer than 15 m. 1 PanoVu PT Series Target Capture Camera*Quick Start Guide Network Cable Alarm Cable Audio Cable Power Cord (12 VDC) GND Figure 1-2 Cables of Camera 1.3 Alarm Output Alarm output is shown in Figure 1-3. GND Output DC 30V 1A Power Supply JQC-3FG Relay (10A 250VAC) Direct load Relay Output OUT (n) OUT (n) + DC - ~220V AC Relay Output OUT (n) OUT (n) Figure 1-3 Alarm Output 2 FireWire Zero Line PanoVu PT Series Target Capture Camera*Quick Start Guide 2 Installation Before you start: Check the package contents and make sure that the device in the package is in good condition and all the assembly parts are included. Notes: Do not power up the camera until the installation is finished. To ensure the safety of personnel and equipment, all the installation steps should be done with power supply off. Do not drag the camera with its waterproof cables; otherwise the waterproof performance is affected. Figure 2-1 Do not Drag 3 PanoVu PT Series Target Capture Camera*Quick Start Guide 2.1 In
icle Batteries Fig 2.6 User Manual of DS-8100HMI-B Series Mobile Net DVR (V1.0) 2.6 Alarm Output Connection Guide Typical Sample Alarm Out DC Load Alarm Out (n)A (n)B JJ1 AC Load Mobile DVR GND (n)A DC +- (n)B JJ1 Output 12V DC Relay AC (n)A On-Off Output JQC-3FG Relay (10A 250VAC) Power Supply (n)B 220V AC Live Wire Zero Line Please kindly pay attention to different connection for JJ1. While connecting to DC load, the 2 connection mode for JJ1 are both ok, yet it is suggested to use it under 12V,1A. While connecting to AC load, then JJ1 must be open (unplug the short-circuit port on main board). For safety consideration, it is recommended to use external relays while connecting to AC load (As the right side figure shows).There are 4 short-circuit port on main board that refers to each alarm output channels JJ1, JJ2, JJ3, JJ4, which are all in short-circuit mode by default, and must be unplugged while connecting to AC load. Warnings! Short-circuit port must be unplugged on connect to AC load, and