ns shall non exceed 0.15mm (0.006 inch) - Critical dimensions are "a3", "E" and "G". e t le Figure 9. PowerSO-36 Scheme ) s ( ct u d o r P e t e l o s b O 12/15 o s b O - o r P ) s t( VN808 Table 11. Order Codes Package Tube Tape and Reel PowerSO-36 VN808 VN80813TR c u d e t le ) s ( ct ) s t( o r P o s b O - u d o r P e t e l o s b O 13/15 VN808 Table 12. Revision History Date Revision 13-Sep-2005 4 Changes Final release c u d e t le ) s ( ct u d o r P e t e l o s b O 14/15 o s b O - o r P ) s t( VN808 c u d e t le ) s ( ct ) s t( o r P o s b O - u d o r P e Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are subject to change withou

-3 Technology, intended for driving any kind of load with one side connected to ground. Active current limitation combined with thermal shutdown and automatic restart, protect the device against overload. PowerSO-36 ORDER CODES PACKAGE PowerSO-36 TUBE T&R VN80813TR VN808 In overload condition, channel turns off and back on automatically so as to maintain junction temperature between TTSD and TR. If this condition makes case temperature reach TCSD, overloaded channel is turned off and will restart only when case temperature has decreased down to TCR (see waveform 3 page 8). Non overloaded channels continue to operate normally. Device automatically turns off in case of ground pin disconnection. This device is especially suitable for industrial applications conform to IEC 1131 (Programmable Controllers International Standard). BLOCK DIAGRAM V CC UNDERVOLTAGE DETECTION VCC CLAMP INPUT 1 GND INPUT 2 CLAMP POWER OUTPUT 1 INPUT 3 OUTPUT 2 INPUT 4 CURRENT LIMITER OUTPUT 3 INPUT 5 INPUT 6 LOGIC JUNCTION T

do not include mold flash or protusions - Mold flash or protusions shall non exceed 0.15mm (0.006 inch) - Critical dimensions are "a3", "E" and "G". Figure 9. 12/15 PowerSO-36 Scheme VN808 Table 11. Order Codes Package Tube Tape and Reel PowerSO-36 VN808 VN80813TR 13/15 VN808 Table 12. 14/15 Revision History Date Revision 13-Sep-2005 4 Changes Final release VN808 Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are not authorized for use as critical components in life support devices or system