| ***Spare part*** SIMATIC DP, Connection ET 200M IM 153-2 FO High Feature for max. 8 S7-300 modules, with redundancy capability, With integr. LWL interface for addition of an optical line |
| General information |
| Vendor identification (VendorID) | 8071h |
| Supply voltage |
| Rated value (DC) | |
| 24 V DC | Yes |
| permissible range, lower limit (DC) | 20.4 V |
| permissible range, upper limit (DC) | 28.8 V |
| external protection for power supply lines (recommendation) | not necessary |
| Mains buffering |
| Mains/voltage failure stored energy time | 5 ms |
| Input current |
| Current consumption, max. | 500 mA; at 24 V DC |
| Inrush current, typ. | 3.5 A |
| I²t | 0.1 A²·s |
| Output voltage |
| Rated value (DC) | 5 V |
| Output current |
| for backplane bus (5 V DC), max. | 1 A |
| Power loss |
| Power loss, typ. | 4.5 W |
| Address area |
| Addressing volume |
| Inputs | 128 byte |
| Outputs | 128 byte |
| Hardware configuration |
| Number of modules per DP slave interface, max. | 8 |
| Time stamping |
| Accuracy | 10 ms; 10 ms / 3 ms |
| Number of message buffers | 15 |
| Messages per message buffer | 20 |
| Number of stampable digital inputs, max. | 128 |
| Time format | RFC 1119 Internet (ISP) |
| Time resolution | 1 ms |
| Time interval for transmitting the message buffer if a message is present | 1 000 ms |
| Time stamp on signal change | rising / falling edge as signal entering or exiting |
| Interfaces |
| Transmission procedure | FOC, wavelength 660 nm |
| PROFIBUS DP |
| Node addresses | 1 to 125 permitted |
| automatic detection of transmission rate | Yes |
| Transmission rate, max. | 12 Mbit/s; 9,6 / 19,2 / 45,45 / 93,75 / 187,5 / 500 kbit/s; 1,5 / 12 Mbit/s |
| SYNC capability | Yes |
| FREEZE capability | Yes |
| Direct data exchange (slave-to-slave communication) | Yes; Sender |
| Design of electrical connection of PROFIBUS interface | Optical, 2 x duplex sockets |
| 1. Interface |
| PROFIBUS DP slave |
| GSD file | (for DPV1) SIEM8071.GSD; SI018071.GSG (for IM 153-2AB0x); SI028071.GSG (for IM 153-2BB0x) |
| automatic baud rate search | Yes |
| Protocols |
| Bus protocol/transmission protocol | PROFIBUS DP to EN 50170 |
| Protocols (Ethernet) |
| TCP/IP | No |
| Potential separation |
| Potential separation exists | Yes |
| Isolation |
| Isolation tested with | Isolation voltage 500 V |
| Degree and class of protection |
| IP degree of protection | IP20 |
| Ambient conditions |
| Ambient temperature during operation |
| min. | 0 °C |
| max. | 60 °C |
| Altitude during operation relating to sea level |
| Installation altitude above sea level, max. | 3 000 m |
| Configuration |
| Configuration software |
| STEP 7 | Yes; STEP 7 / COM PROFIBUS / non-Siemens tools via GSD file |
| Dimensions |
| Width | 40 mm |
| Height | 125 mm |
| Depth | 117 mm |
| Weights |
| Weight, approx. | 360 g |
| last modified: | 03/29/2019 |
