| SIMATIC DP, 5 electronic modules for ET 200S, 4 DO standard 24 V DC/2 A, 15 mm width, 5 units per packing unit |
| Supply voltage |
| Reverse voltage protection | Yes; when using the same load voltage as on the power module |
| Load voltage L+ |
| Rated value (DC) | 24 V; From power module |
| Reverse polarity protection | Yes |
| Input current |
| from load voltage L+ (without load), max. | 10 mA; Per channel |
| from backplane bus 3.3 V DC, max. | 10 mA |
| Power loss |
| Power loss, typ. | 1.6 W |
| Address area |
| Address space per module |
| Address space per module, max. | 1 byte |
| with packing | 4 bit |
| Digital outputs |
| Number of digital outputs | 4 |
| Short-circuit protection | Yes |
| Response threshold, typ. | 2.8 to 7.2 A |
| Limitation of inductive shutdown voltage to | Typ. L+ (-55 to -60 V) |
| Controlling a digital input | Yes |
| Switching capacity of the outputs |
| on lamp load, max. | 10 W |
| Load resistance range |
| lower limit | 12 Ω |
| upper limit | 3 400 Ω |
| Output voltage |
| for signal "1", min. | L+ (-1.0 V) |
| Output current |
| for signal "1" rated value | 2 A |
| for signal "1" permissible range, min. | 7 mA |
| for signal "1" permissible range, max. | 2.4 A |
| for signal "0" residual current, max. | 0.1 mA |
| Output delay with resistive load |
| "0" to "1", max. | 50 µs; Typ. 45 µs |
| "1" to "0", max. | 120 µs; Typ. 90 µs |
| Parallel switching of two outputs |
| for uprating | No |
| for redundant control of a load | Yes; per module |
| Switching frequency |
| with resistive load, max. | 1 000 Hz |
| with inductive load, max. | 2 Hz; At 0.5 H |
| on lamp load, max. | 10 Hz |
| Total current of the outputs |
| Current per module, max. | 4 A |
| Cable length |
| shielded, max. | 1 000 m |
| unshielded, max. | 600 m |
| Isochronous mode |
| Isochronous operation (application synchronized up to terminal) | Yes |
| Interrupts/diagnostics/status information |
| Diagnostics function | No |
| Diagnostics indication LED |
| Status indicator digital output (green) | Yes |
| Parameter |
| Remark | 1 byte |
| Potential separation |
| Potential separation digital outputs |
| between the channels | No |
| between the channels and backplane bus | Yes |
| Isolation |
| Isolation tested with | 500 V DC |
| Dimensions |
| Width | 15 mm |
| Height | 81 mm |
| Depth | 52 mm |
| Weights |
| Weight, approx. | 40 g |
| last modified: | 03/18/2019 |
